12VDC RGB LED Controller 20 Keys
The RGB Controller is used to control 12 Volt RGB LED Light Bars and Light Strips with common anode wiring, such as our xFLS-RGB series Light Strip. Using the included hand held wireless remote controller for direct accessability to all modes, RGB Light Strips can be set to one of eight different static colors or one of six different dynamic color changing patterns. The remote control can also adjust pattern speed, brightness, play/pause, and turn system ON and OFF. With 12 Amp continous load capability, the LDRF-RGB4 can drive up to 30 meters of our xFLS-RGB Light Strips. For longer runs use our RGB Amplifiers.

Controller Connections

Product Specifications

NOTES:

1.) Only power with 12VDC Power Supply and connect to 12 Volt Light Strips or unit will be damaged. Our Compact 50Watt and 24 Watt Power Supplies will plug into DC IN jack on left side of unit. Our Enclosed Power Supplies can be direct wired to "+" and "-" terminals on removable Green connector on right side of unit.
2.) Wireless controller uses one 23A, 12V battery. 
3.) Connect according to the above drawing and note that the Green Connectors can be unplugged from the unit.
4.) Red LED will come on when unit is receiving power, Green LED will flash when RF signal is received from handheld transmitter.
5.) UP and DOWN buttons will only work when unit is in one of the four color-changing (dynamic) modes.
6.) Each Controller has a handheld Remote matched to it and will only work with it's matched Remote. One Remote cannot operate multiple Controllers.
7.) Controller can control a maximum of 30 meters of our Flexible RGB LED Strip. Over 30 meters, the Strips have to connect with an amplifier to reinforce the transmission of signal. Use one RGB Amplifier for every 30 meters of additional LED Strips.
8.) Do not exceed 80% of Power Supply capacity when calculating Power Supply size to use in your system.

RF Remote Control

Dimensions

Dimensions in millimeters (inches)

Typical Wiring Schematic